Serial 1 And Serial 2 (5260) Or Serial (5230) Configuration Menus - Verilink WANsuite 5260 Reference Manual

Figure 5.15
Coding Sets the DSX port line coding.
CRC4 Mode Provides line integrity detection to determine if bit errors are present on the
line.
Channel Map Menu The CHANNEL MAP menu allows channels to be allocated/unallocated to
the NET 2 interface. The values for this option are:
•
•
•
There is no default value for this option.
Serial 1 and Serial 2 (5260) or Serial (5230) Configuration
Menus
Use the SERIAL 1 CONFIG and SERIAL 2 CONFIG on the WANsuite 5260
and SERIAL CONFIG on the WANsuite 5230 to set the configuration
parameters defined in the following paragraphs. The submenus and options
are the same for both SERIAL 1 CONFIG and SERIAL 2 CONFIG menus on
the 5260 and the SERIAL CONFIG menu on the 5230.
Network 2 Configuration Menu Tree
CRC4 Mode
Coding
HDB3
AMI
Values: HDB3, AMI
Default:HDB3
Values: Disable, Enable
Default:Disable
Idle − Channel not allocated
Thru − Allocated to NET 2
T+Sig − Allocate and Signaling enabled
Net 2
Config
Channel Map
Dis
Channel 1
En
Channel 31
F r o n t P a n e l L C D I n t e r f a c e
Idle
Thru
T+Sig
Idle
Thru
T+Sig
5-15