Verilink WANsuite 5260 Reference Manual page 212

Type
X.21
V.35
RS-232
EIA-530
Inv Clock Rate
Nx64K
Dis
Nx56K
En
(N = 1–32)
Type
Mode
5-16 W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 5.16 Serial 1 and Serial Interface 2 (5260) or Serial (5230)
Configuration Menu Tree
Serial 1
Config
Mode DSR DCD
DCE True
DTE False False
Int
Ch Rate
Bundling
Nx64K
Cont
Nx56K
Alt
Selects the type of interface (based on its electrical signal characteristics) used
by the equipment connected to the Serial port.
Values: X.21, V.35, RS-232, EIA-530
Default:V.35
NOTICE:
V.35 requires the use of an optional cable. Refer to Optional Equipment
on page A-6 for ordering information.
By default, the Serial port serves as a DCE port in both Packet and TDM
modes. However, the Serial port can serve as a DTE port when the unit is in
Packet mode.
If the Serial port connects to a DTE device (such as a FRAD or a router), you
must set this Mode parameter to "DCE." If this port connects to a DCE device
(such as a DSU/CSU), you must set this Mode parameter to "DTE" (valid
only for Packet mode, not TDM).
Values: DCE, DTE
Default:DCE
NOTICE:
DTE mode requires the use of an optional DTE cable. Refer to
Appendix A for ordering information.
Serial 2
Config
CTS RTS
True True Normal
False True
Int
Int
Start Ch # of Ch
1–31 1–31
RTS Dly Tx Clock
Normal Int
Long Ext
DTR
LL
V.54
Ctrl
Dis Dis Dis
En En En