Supervisory Configuration Menu - Verilink WANsuite 5260 Reference Manual

LL The Local Loopback (LL) parameter can be set to "Enable" or "Disable."
Selecting "Enable" allows the unit to go into LL when the LL pin on the
Serial port goes high. The unit exits the loop when the LL pin goes low. If
you select "Disable," the unit ignores the LL pin on the Serial port.
Values: Disable, Enable
For more information on pin assignments, refer to Connector Pin Assignments
on page A-7.
DTR Control Lets you set the Data Terminal Ready (DTR) alarm control parameters.
Choices for DTR Alarm Control are "Enable" and "Disable." Setting DTR
Alarm Control to "Enable" allows the unit to go into alarm on a loss of DTR.
Values: Disable, Enable

Supervisory Configuration Menu

Use the SUPV CONFIG menu to set up parameter values for the Supervisory
port as shown in Figure 5.17 and defined in the paragraphs below.
Figure 5.17
Speed Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Ch Size Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Stop Bits Selects the number of bits required to end the asynchronous character.
Values: 1, 2
Default: 1
Parity Sets the parity bit.
Values: None, Odd, Even
Default: None
DTR Alarm Sets the DTR Alarm.
Values: Enable, Disable
Default: Disable
Default:Disable
Default:Disable
Supervisory Configuration Menu
Speed Ch Size Stop Bits
Five
1200, 2400,
4800,9600, Six
Seven
19200, 38400,
57600, 115200 Eight
Supv
Config
Parity DTR Alarm
1
None Dis
2 En
Odd
Even
F r o n t P a n e l L C D I n t e r f a c e
Diag Msgs
Dis
En
5-19