Rule Configuration Screen - Verilink WANsuite 5260 Reference Manual

shows the Tx Alarm Threshold and the current Tx Alarm status (if enabled)
for each rule.
It is also possible to filter PPP services, in which case all information related
to DLCIs is ignored.
Figure 3.35 Service Aware Screen
NOTICE:
If you change a Service parameter, you must click on "Submit" to
display the appropriate DLCIs.
The Service Aware screen provides the following user-activated buttons:
Button Function
Rule Details Displays the Rule Configuration screen (page 3-45).
Traffic Meter Stats* Displays the Traffic Meter Statistics screen (page 3-47).
Clear Alarms Clears all Service Aware alarms.
Refresh Refreshes data on the current page.
* These three buttons are not shown in the partially captured screen shown above, but you will find them at the
bottom of the actual configuration screen.

Rule Configuration Screen

Use the Rule Config screen (Figure 3.36) to establish Service Aware
parameters. To establish a rule, select the desired rule configuration options,
provide the appropriate filter information where required, and click on the
"Submit" button at the bottom of the screen.
W e b S e r v e r I n t e r f a c e 3-45