Table of Contents
Advertisement
Parity
Stop Bit
DTR Alarm Control
DTR Alarm Status
Diagnostic Messages
Current Pin Status
Service Table Screen
4-18
W A N s u i t e 5 2 6 0 / 5 2 3 0
Sets the parity bit.
Values: None, Odd, Even
Default: None
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1
Lets you set DTR Alarm Control parameters. Selecting "Enable" allows the
unit to go into alarm on loss of DTR, which occurs when the Supervisory port
detects that the DTR signal is low.
Values: Enable, Disable
Default: Disable
Lets you view the current DTR Alarm status.
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
NOTICE:
When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
"Disable."
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Supervisory interface screen.
The Service Table screen (Figure 4.14) provides a view of the unit's defined
services and displays the Interface, Type, and Pair parameters for each
service.
Advertisement
Table of Contents
