Table of Contents
Advertisement
Diag Msgs
Utilities Menu
5-20
W A N s u i t e 5 2 6 0 / 5 2 3 0
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default:Enable
NOTICE:
When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
"Disable."
Use the UTILITIES menu to display and change some system operational
configurations.
Figure 5.18
Utilities Menu Tree
Maintenance Reset
This screen lets you reset the unit to its factory default TDM or Packet
configuration for all unit parameter values. Use the "Save" option to write the
current configuration to the unit's non-volatile memory. The "No" option is
displayed as a null state only before you select and scroll through
Maintenance Reset options − it serves as protection from accidentally
resetting the unit.
Values: No, TDM, Save, Packet, Packet 3, Packet 4
Default:No
Set Password
The Set Password screen lets you establish or change an access password for
entry to and control of the front panel interface. The password will consist of
a selection of up to eight alphanumeric characters. After selecting and then
exiting password entry, the front panel will require that you enter this same
selection of coded values before the display will move beyond the "idle"
screen.
Selecting the Set Password option will open the ENTER PASSWORD screen;
a blinking cursor appears over the first character or digit to be entered or
modified. To establish a unit password, press the
the characters and digits (0– 9, A–Z, a– z). Pressing the
accepts the value and moves the cursor to the right. After entering all the
Utilities
Maintenance
Set
Reset
Password
No
Enter Password
Save
TDM
Pkt
Pkt 3
Pkt 4
button to increment
SCROLL
button
SELECT
Advertisement
Table of Contents
