Table of Contents
Advertisement
DSR
Data Set Ready (DSR) can be set to "True," "False," or "Internal." The
"Internal" option sets DSR "On" if the port is enabled and "Off" if the port is
disabled.
Values: True, False, Internal
DCD
The Data Carrier Detect (DCD) parameter can be set to "True," "False," or
"Internal." If set to "Internal," DCD is "On" when network carrier is being
received from the remote end, and is "Off" when network carrier is not being
received from the far end.
Values: True, False, Internal
CTS
The Clear To Send (CTS) parameter can be set to "True" or "False." If this
parameter is set to "Internal," the CTS control lead follows the RTS control
lead from the DTE after a delay of a duration established by the RTS Delay
parameter.
Values: True, False, Internal
RTS
The Request To Send (RTS) parameter determines where the unit reads the
RTS signal status from. If set to "Normal," the unit gets RTS from the Serial
pin. If set to "True," RTS is always perceived as "On."
Values: Normal, True
RTS Delay
The RTS Delay parameter determines how long the unit waits before it
changes the level of CTS to match RTS when the CTS parameter is set to
"Internal."
Values: Normal (~30 ms delay), Long (~100 ms delay)
Tx Clock
Selects the clock the unit used to sample the data transmitted from the DTE.
When set to "Internal," the data is sampled directly with the transmit data
clock that is also supplied to the DTE as Transmit Clock. The "External"
option uses the external clock from the DTE (valid only in Packet mode).
Values: Internal, External
Inv Clock
In DTE Packet mode, changes the clock edge of the data transmitted.
Values: Enable, Disable
Rate
If the port is running in Packet mode, the Rate must be configured to the
desired port speed. In TDM mode, the port speed rate will be set by
Default:True
Default:True
Default:True
Default:Normal
Default:Normal
Default:Internal
Default:Disable
F r o n t P a n e l L C D I n t e r f a c e
5-17
Advertisement
Table of Contents
