Supervisory Screen - Verilink WANsuite 5260 Reference Manual

Supervisory Screen

Speed
Character Size
Diagnostic Messages
Parity
Stop Bit
3-16 W A N s u i t e 5 2 6 0 / 5 2 3 0
The Supervisory screen (Figure 3.11) displays the current speed of the
Supervisory port interface and other parameters as described below.
Figure 3.11 Supervisory Screen
A "Refresh" button is provided on this screen to update the displayed
information. Click on the "Supervisory Services" button at the bottom of the
screen to view service information for the Supervisory interface.
Changes the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default: 19200
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
Enables the Supervisory port to send out diagnostic messages upon power-up.
Values: Enable, Disable
Default: Enable
NOTICE:
When in SCADA mode, these diagnostic messages disrupt the connected
device. Therefore, if using the SCADA mode, set this value to
"Disable."
Sets the parity bit.
Values: None, Odd, Even
Default: None
Selects the number of bits required to end the character.
Values: 1, 2
Default: 1