Rear Panel Connections - Verilink WANsuite 5260 Reference Manual

Rear Panel Connections

The user-activated input control buttons used to access and set configuration
and control options from the LCD menus are defined in the table below:
Button Description
EXIT EXIT
The button exits a menu option, which then places the unit in the next
higher level of the menu hierarchy. If you are editing an option, pressing
exits that screen without saving any changes. If you are in the main menu,
EXIT
pressing
SCROLL SCROLL
The
the menu hierarchy or scroll through possible settings for a parameter. You can
SCROLL
also use the
scrolling incrementally through digits 0–9 or letters A–Z and a–z.
SELECT SELECT
The
given field, and enter an "edit" mode for parameters that require user-specified
input. Additionally, you can use the
or settings. If this button is held during power-up reset, the configuration is
forced to packet defaults.
The rear panel of the WANsuite 5260 has 11 connectors. From left to right
these are as follows:
POWER
, ,
SERIAL 2 SERIAL 1 NET 2 (75
Ω
NET 1 (75 TX), NET 2 (120
below. serves as the
NET 2
Figure 1.2 WANsuite 5260 Rear Panel
The rear panel of the WANsuite 5230 has 7 connectors. From left to right,
these are as follows:
POWER, SUPERVISORY PORT, 10/100 ETHERNET,
NET (75 Ω Rx), NET (75 Ω Tx), NET (120 Ω)
, and
SERIAL
1.3 below. The WANsuite 5230 has one E1 port to which you may connect
using either the 75-ohm BNC or the 120-ohm RJ-48C. Refer to, Network 1
Interface (5260) and Network Interface (5230) on the following page for more
information.
Figure 1.3 WANsuite 5230 Rear Panel
logs off the unit.
button lets you review the available options for a given level in
button to set alphanumerical values, where applicable, by
button lets you select the currently displayed option or value for a
SELECT
,
SUPERVISORY PORT
Ω
RX), NET 2 (75
Ω), Ω
NET 1 (120 )
or
E1 Equipment Port
A b o u t t h e W A N s u i t e 5 2 6 0 / 5 2 3 0
EXIT
button to confirm certain actions
,
10/100 ETHERNET
Ω Ω
TX), NET 1 (75 RX),
as shown in Figure 1.2
for the unit.
DSX Port
as shown in Figure
,
1-9