Led Indicators - Verilink WANsuite 5260 Reference Manual

5-2 W A N s u i t e 5 2 6 0 / 5 2 3 0
The table below provides a brief description of the WANsuite 5260/5230's

LED indicators.

Indicator Description
NET
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when the E1 link is down.
The indicator lights amber when the E1 link is up and at least one
configured protocol is not established.
The indicator lights green when the E1 link is up and all configured
protocols are established.
NOTE: TDM is considered a protocol. It is established whenever the E1
link is up.
SERIAL #1
Port in DTE Mode:
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DSR is not active and the configured
protocol is not established.
The indicator lights amber when DSR is not active or the configured
protocol is not established.
The indicator lights green when DSR is active and the configured
protocol is established.
DTR Alarm Enabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights red when DTR is not active and the configured
protocol is not established.
The indicator lights amber when DTR is not active or the configured
protocol is not established.
The indicator lights green when DTR is active and the configured
protocol is established.
DTR Alarm Disabled (Port in DCE Mode):
This indicator is off (not illuminated) when the port has not been
configured.
The indicator lights green when the configured protocol is established.
The indicator lights red when the configured protocol is not established.
SERIAL #2 (Same as
(5260 Only)
ALARM
This indicator lights red if an alarm condition exists.
(5230 Only)
The indicator lights amber if a "yellow" alarm condition exists.
POWER This indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (Port looped or BERT active).
SERIAL #1
)