Trap Log Screen - Verilink WANsuite 5260 Reference Manual

Errored Seconds
%EFS

Trap Log Screen

Displays the number of asynchronous errored seconds that have been detected
since the test began or since error statistics were last cleared.
Displays the percentage of time that the test ran error-free. This ratio is
derived from the number of error-free seconds divided by the number of
seconds accumulated in Elapsed Time.
Loop Table on Serial Interface Test Details Screen
The Loop table provided near the bottom of the Test Details screen lets you
specify the type of Loop test to be performed. The types of tests available for
you to choose from depend on the currently selected interface.
Values: No Test (Loop Down), Port Loop, V.54 Loop, Far V.54 Loop
Default: No Test (Loop Down)
Both the Network Interface and the Serial Interface Test Details screens
provide the following user-activated buttons:
Button Function
Start Starts the specified BERT.
Stop Stops the currently running BERT.
Error Inject Injects a bit error.
Reset Errors Resets the current error count.
Loop Submit Sets the type of Loop test.
Refresh Refreshes data on the current page.
The Trap Log screen (Figure 3.42) shows a collection of all the traps that
have been generated. A trap is a mechanism that permits a device to send an
alarm for certain network events to an SNMP management station. In other
words, traps are notifications of triggered alarms.
The table shown in this screen lists each trap by its Index number, and
displays the type of error captured by the trap (Trap Number), the date and
time the trap was stored (Time Stamp), its description, and its value.
Click the "Refresh" button at the top of the screen to display the latest trap
information in the table. To remove all trap information stored in memory,
click the "Delete All Traps" button.
W e b S e r v e r I n t e r f a c e 3-53