Verilink WANsuite 5260 Reference Manual page 72

Remote Unit
Round Trip Delay Size
(bytes)
Round Trip Delay Rate
(secs)
Status
Receiving FECN/
BECN
CIR Threshold
CIR Alarm
Bits Over Be Threshold
Bits Over Be Alarm
Congestion Threshold
Congestion Alarm
3-42 W A N s u i t e 5 2 6 0 / 5 2 3 0
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery is
enabled, this field displays the first three digits of the unit ID configured on
the remote end of this DLCI.
Values: 000 − 999
Default: 000
Specifies the frame size (in bytes) of packets making the round trip. If the
Round Trip Delay Size is not configured, the Frame Relay Details values will
be used.
Specifies the rate (in seconds) at which Round Trip Delay packets are sent. If
the Round Trip Delay Rate is not configured, the Frame Relay Details values
will be used.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of
DLCI and alarm threshold information as follows:
If this DLCI is up, the status will be "Active"; otherwise, the status will be
"Inactive."
Values: Active, Inactive
Default: Inactive
When a frame is received with congestion bit set, this parameter is set to
"Yes." It is set back to "No" when a frame is received without congestion bit
set.
Values: Yes, No
Default: No
Sets the Tx over CIR alarm threshold. This threshold is the number of bits per
second in excess of CIR during a 15-minute interval. Setting this field to "0"
(zero) disables the alarm.
Reports if the Tx over CIR threshold has been exceeded.
Sets the Tx over excess burst alarm threshold. This threshold is the number of
bits per second in excess of CIR + Be during a 15-minute interval. Setting
this field to "0" (zero) disables the alarm.
Reports if the Tx over Be threshold has been exceeded.
Sets the Rx Congestion alarm threshold. This threshold is the number of
frames received with BECN/FECN. Setting this field to "0" (zero) disables
the alarm.
Reports if the Rx Congestion threshold has been exceeded.