Verilink WANsuite 5260 Reference Manual page 104

Global Port
Server Port
Server Address
3-74 W A N s u i t e 5 2 6 0 / 5 2 3 0
Static UDP Translation Table Screen
The Static UDP Translation Table screen (Figure 3.64) allows static mapping
of global UDP Server ports to a local host IP address/port combination. The
parameters described below enable access to UDP Servers on the private/
corporate network "behind the NAT." The parameters may be used only when
in NAPT mode.
Figure 3.63 Static UDP Translation Table Screen
Decimal IP Port exposed to the global Internet. Default is 0.
Decimal IP Port of the local UDP Server. This port is usually the same as the
Global Port. Default is 0.
IP Address of the local UDP Server. Default is 0.0.0.0.
The Static UDP Translation Table screen provides the following user-activated
buttons:
Button Function
NAT Details Returns the user to the previous screen.
Add New Lets the user add an additional address.
Refresh Refreshes data on the current page.
You can configure or change the above-listed parameters on the Static UDP
Translation Details screen (Figure 3.64), which is accessed by selecting the
appropriate number under the "Index" column on the Static UDP Translation
Table screen.
Figure 3.64 Static UDP Translation Details Screen