Service
DLCI
Filter By DLCI
IP Address
IP Mask
Filter By IP Address
3-46
W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 3.36
Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options.
Selects the service to which the rule applies. Select from a pull-down menu
that lists available services.
NOTICE:
If you change the Service parameter, you must click on "Submit" to see
the appropriate DLCIs.
Selects the DLCI to which the rule applies from a pull-down list of applicable
DLCIs.
Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.
NOTICE:
To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.
Establishes the IP address by which the rule will filter IP traffic (if enabled).
Represents a range of IP addresses defined so that only machines with IP
addresses within the range defined by the mask are allowed to access an
Internet service. To mask a portion of the IP address, replace it with the wild
card character "0" (zero). (For example, 192.44.0.0 represents every computer
on the Internet with an IP address beginning with 192.44.)
Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.