Dtr Alarm Control And Status Table; 10/100 Ethernet Screen (Ip Service Details) - Verilink WANsuite 5260 Reference Manual

10/100 Ethernet Screen (IP Service Details)

Unit IP Address
Subnet Mask
3-14 W A N s u i t e 5 2 6 0 / 5 2 3 0

DTR Alarm Control and Status Table

In addition to the configurable fields, the Serial screens display a table that
lets you set the Data Terminal Ready (DTR) Alarm Control parameters and
view the current DTR Alarm Status.
Choices for DTR Alarm Control are "Enable" and "Disable." The default
setting is "Disable." Setting DTR Alarm Control to "Enable" allows the unit
to go into alarm on a loss of DTR, which occurs when the Serial port detects
that the DTR signal is low. The DTR Status field indicates the current state of
the DTR alarm.
The Serial screens provide the user-activated buttons described in the
following table:
Button Function
Submit Sets any values that have been changed.
Serial 1 Services Displays the Services screen for Serial #1 interface.
Refresh Refreshes data on the current page.
To make changes to any Serial port parameter, simply set the parameter to the
desired selection and click the "Submit" button.
The 10/100 Ethernet (IP Service Details) screen (Figure 3.9) lets you
configure the IP parameters described below.
Figure 3.9 10/100 Ethernet (IP Service Details) Screen
A unique network address assigned to this unit.
Defines the network portion of the unit's IP address.