Verilink WANsuite 5260 Reference Manual page 142

Enforce CIR and Be
Management DLCI
Management Auto IP
DLCI
FrameStart Auto
Diagnostic
FrameStart Auto
Discovery
RFC1315 Trap
4-26 W A N s u i t e 5 2 6 0 / 5 2 3 0
network side to gather statistics and to perform CIR enforcement, if required.
If a DLCI is configured with an Excess Burst different from the default, the
DLCI configuration will be used instead.
Values: 0–2048000 bps
Default: 0
If this parameter is set to "Yes," the unit will enforce Committed Information
Rate and Excess Burst according to the Link Injection Parameter.
Values: No, Yes
Default: No
NOTICE:
The Auto Diagnostic parameter must be set to "Yes" to enforce CIR and
Be.
If this parameter is set to "0," the unit will look for management traffic on
any DLCI. If set to a number associated with a specific DLCI, the unit will
look for management traffic on that DLCI only.
If this parameter is set to "Yes," the unit will monitor the specified
management DLCI for 5 pings over 5 seconds, after which the unit uses the
destination address as its management IP address.
When this parameter is set to "Yes," the unit will always source LMI on both
sides of the frame relay connection. The unit will dynamically learn the type
of link management used on each side of the connection (Network and
Serial).
When set to "No," the unit will monitor LMI between the serial and the
network port. If one side of the connection goes down, the other side will stop
receiving LMI.
FrameStart Auto Diagnostic mode should be left set to "Yes" unless the frame
relay connection has more that 128 DLCIs, or if there is a very high traffic
rate on a constant basis.
Values: No, Yes
Default: Yes
When this parameter is set to "Yes," the unit will send FrameStart discovery
and delay frames to each DLCI it learns as soon as the DLCIs are set active.
This is required to calculate round-trip delay as well as to discover remote
WANsuite 5260/5230/FSE units. This parameter should be set to "Yes" only
on network services that have a WANsuite 5260/5230/FSE at the far end of
the frame relay connection.
Values: No, Yes
Default: No
When this parameter is set to "Enable," the unit will send the standard
RFC1315 frame relay DTE circuit state change trap every time a DLCI