Table of Contents
Advertisement
Current
Interval 1,
Interval 2,...,
Interval 96
SNMP Details Screen
Read Community
Write Community
Trap Community
Trap IP Address
Diagnostics Screen
4-48
W A N s u i t e 5 2 6 0 / 5 2 3 0
Reports on the current 15-minute interval.
Reports on Intervals 1-96, which correspond to the periods completed 15
minutes ago, 30 minutes ago,..., 24 hours ago.
The unit detects and reports E1 network alarms and provides several options
for reporting them, one of which is SNMP traps. When a network alarm
occurs, the unit sends a trap message to as many as eight destinations on your
network. The unit will report each alarm by transmitting an SNMP "trap" to
each non-zero Trap IP address.
The SNMP Details screen (Figure 4.40) lets you configure the SNMP
parameters described in the paragraphs below.
Figure 4.40
SNMP Details Screen
Accepts a character string identifying the group authorized to perform read
operations. The default setting is "Public."
Accepts a character string identifying the group authorized to perform write
operations. The default setting is "Private."
Accepts a character string, which is included in SNMP traps generated by the
unit. The default setting is "Public."
Accepts the IP address of a network device where alarm reporting traps are to
be sent.
The Diagnostics screen (Figure 4.41) provides a table for viewing the current
settings for the test and maintenance functions performed on the available
interfaces. This screen shows an upper-level view of all the interfaces so you
Advertisement
Table of Contents
