Table of Contents
Advertisement
Copyright Notice
Trademarks
Documentation
Disclaimer
Warranty
Emissions
Canadian Emissions
Requirements
Safety Precautions
ii
W A N s u i t e 5 2 6 0 / 5 2 3 0
Copyright © 2002 Verilink Corporation. All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language
in any form by any means without the written permission of Verilink.
Manual Reorder # 34-00304.F
April 2002
®
®
Verilink
and WANsuite
are registered trademarks of the Verilink Corporation. FrameStart™
and ServiceAware™ are trademarks of the Verilink Corporation.
All other brand and product names used herein are trademarks or registered trademarks of their
respective manufacturers.
This document does not create any express or implied warranty about Verilink or about its prod-
ucts or services. Verilink's sole warranty is contained in its product warranty. The end-user doc-
umentation is shipped with Verilink's products and constitutes the sole specifications referred to
in the product warranty. Verilink has made reasonable efforts to verify that the information con-
tained herein is accurate, but Verilink assumes no responsibility for its use or for any infringe-
ment of patents or other rights of third parties that may result. The customer is solely
responsible for verifying the suitability of Verilink's products for its use. Specifications are sub-
ject to change without notice.
Verilink's product warranty is included at the back of this document.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to applicable requirements. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user is required to correct the interference at his own expense. This device must
also accept any interference received, including interference that may cause undesired operation.
WARNING: For use only with a certified Class 2 power supply. See Power Source in
Appendix A, Specifications.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of Commu-
nications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites appli-
cables aux appareils numériques (de la class A) prescrites dans le Règlement sur le brouillage
radioélectrique edicté par le ministère des Communications du Canada.
When handling this equipment, follow these basic safety precautions to reduce the risk of elec-
tric shock and injury:
•
Follow all warnings and instructions marked on the product and in the manual.
•
Unplug the hardware from the wall outlet before cleaning. Do not use liquid cleaners or aerosol clean-
ers. Use a slightly damp cloth for cleaning.
•
Do not place this product on an unstable cart, stand, or table. It may fall, causing serious damage to
the product.
•
Slots in the unit are provided for ventilation to protect it from overheating. These openings must not
be blocked or covered. Never place this product near a radiator or heat register.
Advertisement
Table of Contents
