Table of Contents
Advertisement
Be (bps)
Bc (bps)
Discard Eligible Flag
In Band Management
FrameStart Delay
FrameStart Status
Remote DLCI
If an Excess Burst Rate is configured here, its value will be used instead of
the default excess burst of the Frame Relay service.
Values: 0–2048000
Default: 0
If CIR enforcement is configured to "Yes," the unit will throttle the
Committed Burst down to this value when frames are received with the
BECN bit set.
Values: 0–2048000
Default: 0
If this parameter is set to "Yes," and CIR enforcement is also set to "Yes," the
unit will set the Discard Eligible (DE) bit for frames sent over CIR.
Values: Yes, No
Default: No
If the unit is to be used as a gateway to reach a remote WANsuite 5260/5230
through this DLCI, set this parameter to "Yes," and configure the remote IP
address and Mask in the corresponding endpoint.
Values: Yes, No
Default:No
If this parameter is set to "Enable," the unit will send FrameStart discovery
and delay frames on this DLCI, and will report the state of the remote FSx
unit. It will also send SOS frames when the FRAD/router connected to this
unit goes inactive.
Values: Enable, Disable
Default: Enable if Auto Discovery is set to "Yes"; otherwise Disable
If the remote unit is a Verilink FSx product and FrameStart Auto Discovery is
enabled, the FrameStart Status field will show the status of the remote unit.
The status is "Active" if both the local and remote DLCIs are active and the
remote unit answers to the discovery frames sent by this unit. The status is
"SOS" if the remote unit is active but the FRAD/router connected to it is
inactive. The status is "Inactive" in all other cases.
Values: Active, Inactive, SOS
Default: Inactive
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery is
enabled, this field displays the DLCI number used on the remote end of this
DLCI.
Values: 16−1023
Default: 0
W e b S e r v e r I n t e r f a c e
3-41
Advertisement
Table of Contents
