Table of Contents
Advertisement
Gateway IP Address
DHCP Client
Client Identifier
Physical Address
Supervisory Configuration Screen
Speed
Character Size
IP address of the default gateway (router) on the LAN side of the unit.
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Displays a unique identifier for a specific IP address.
Displays unique MAC address.
NOTICE:
Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
NOTICE:
If you manually change the IP address, you must "Save and Restart."
(See Save and Restart on page 4-6.)
The Supervisory Configuration screen (Figure 4.13) displays the current speed
of the Supervisory port interface along with other parameters as described
below. The Supervisory port supports only asynchronous character formats.
Figure 4.13
Supervisory Config Screen
Used to change the Supervisory port speed (in bits per second).
Values: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Default:19200
Selects the number of bits required to make up one asynchronous character.
Values: Five, Six, Seven, Eight
Default: Eight
V T 1 0 0 I n t e r f a c e
4-17
Advertisement
Table of Contents
