Table of Contents
Advertisement
283.01—Sensor (1st scan) static jam service check
Step
1
Check the media path.
Is the media path free of media or media
fragments?
2
Check the sensor (ADF 1st scan) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Observe the line "sensor (ADF 1st can)".
Does the display on the operator panel,
change every time the sensing area of the
above sensor is interrupted or blocked?
3
Check the sensor (ADF 1st scan) for proper
connection.
Is the above component properly
connected?
4
Place an undamaged document in the ADF,
and perform a ADF test.
Does the error remain?
5
Perform a print test using the ADF.
Does the problem remain?
Check
Yes
Go to step 2.
Go to step 4.
Replace the sensor (ADF
1st scan). See
"Sensor
(ADF 1st scan) removal"
on page
4-205.
Replace the ADF controller
card assembly.
See
"ADF controller card
removal" on page
4-174.
Go to step 5.
Contact your next level of
support.
7562
No
Remove any media or
media fragments.
Go to step 3.
Replace the connection.
Problem solved.
Problem solved.
2-127
Diagnostic information
Previous
Next
Go Back
Advertisement
Table of Contents
