Table 16: Network Port Leds On Line Cards In An Ex8200 Switch-Link/Activity; Led; Table 17: Network Port Leds On Line Cards In An Ex8200 Switch-Status - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
Table 16: Network Port LEDs on Line Cards in an EX8200 Switch—Link/Activity LED

LED

Link/Activity
Table 17: Network Port LEDs on Line Cards in an EX8200 Switch—Status LED
LED
Status
40
Color
Green
The LEDs labeled Status in Figure 21 on page 38, Figure 22 on page 39, Figure 23 on
page 39, and Figure 24 on page 39 indicate the status of one of the three port parameters.
The port parameters are administrative status, duplex mode, and speed.
Table 17 on page 40 describes the Status LED. From the Idle menu of the LCD, use the
button on the LCD panel to toggle between the ADM, DPX, and SPD indicators.
Enter
LCD Indicator
LED: ADM
LED: DPX
LED: SPD
State and Description
On steadily—The port and the link are active, but there is no
link activity.
Blinking—The port and the link are active, and there is link
activity.
Off—The port is not active.
State, Color, and Description
Indicates the administrative status (enabled or disabled). The
status indicators are:
Green—Administrative status enabled.
Unlit—Administrative status disabled.
Indicates the duplex mode. The status indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is not set to full-duplex mode.
Indicates the speed. The speed indicators are different in the
line cards.
The speed indicators for 8-port SFP+ line cards are:
Unlit—Less than 10 Gbps
Green—10 Gbps
The speed indicators for 40-port SFP+ line cards are:
Unlit—Less than 10 Gbps
Green—10 Gbps
The speed indicators for 48-port SFP line cards are:
Unlit—Less than 1 Gbps
Green—1 Gbps
The speed indicators for 48-port RJ-45 line cards are:
Unlit—10 Mbps
Green—Blinking—100 Mbps
Green—On steadily—1000 Mbps
Copyright © 2010, Juniper Networks, Inc.