Figure 73: Connecting An Ex Series Switch To A Management Console Through; Figure 74: Connecting An Ex Series Switch Directly To A Management; Console - Juniper EX8208 Complete Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
To connect the device to a management console (see Figure 73 on page 179 and Figure
74 on page 179):
Connect one end of the Ethernet cable into the console port (labeled
1.

CONSOLE

) on the device.
For the location of the
CON/CONSOLE
See Rear Panel of an EX2200 Switch.
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX4200 Switch.
See Front Panel of an EX4500 Switch.
See "Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch" on
page 26.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
Connect the other end of the Ethernet cable into the console server (see Figure 73 on
2.
page 179) or management console (see Figure 74 on page 179).
To configure the device from the management console, see "Connecting and Configuring
an EX Series Switch (CLI Procedure)" on page 188 or "Connecting and Configuring an EX
Series Switch (J-Web Procedure)" on page 190.
Figure 73: Connecting an EX Series Switch to a Management Console
Through a Console Server
To Console port
(on the switch)

Figure 74: Connecting an EX Series Switch Directly to a Management

Console
To Console port
(on the switch)
Connecting an EX Series Switch to a Network for Out-of-Band Management on page 183
Console Port Connector Pinout Information for an EX Series Switch on page 58
Cables Connecting the EX8200 Switch to Management Devices on page 99
port on different devices:
Console server
Laptop CPU
Chapter 10: Connecting the Switch
or
CON
PC
179