Ac Power Cord Specifications For An Ex8200 Switch; Table 48: Ac Power Cord Specifications For An Ex8200 Switch - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches

AC Power Cord Specifications for an EX8200 Switch

Table 48: AC Power Cord Specifications for an EX8200 Switch

Country/Region
Australia
China
Europe (except Italy,
Switzerland, and United
Kingdom)
Italy
Japan
106
Calculating Power Requirements for an EX8208 Switch on page 108
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. Most sites distribute power through a main conduit
that leads to frame-mounted power distribution panels, one of which can be located at
the top of the rack that houses the switch. An AC power cord connects each power supply
to the power distribution panel.
Each detachable AC power cord is 2.5 meters (approximately 8 feet) long. The appliance
coupler at the female end of the cord inserts into the AC appliance inlet on the faceplate
of the AC power supply. The coupler type is C19 as described by the International
Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the
power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 15 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cords shipped with the switch are in
compliance.
Table 48 on page 106 lists the AC power cord specifications for an EX8200 switch for the
countries and regions listed in the table.
Electrical Specifications
250 VAC, 15 A, 50 Hz
250 VAC, 16 A, 50 Hz
250 VAC, 16 A, 50 Hz
250 VAC, 16 A, 50 Hz
250 VAC, 16 A, 50 Hz
Plug Standards
AS/NZS 3112
GB 1002
CEE (7) VII
CEI 23-16
NEMA 6–20
NEMA L6–20
Copyright © 2010, Juniper Networks, Inc.