Related
Documentation
Connecting a Fiber-Optic Cable to an EX Series Switch
Copyright © 2010, Juniper Networks, Inc.
Using both hands, carefully place the transceiver in the empty port. The connectors
4.
must face the switch chassis.
CAUTION: Before you slide the transceiver into the port, ensure the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
Slide the transceiver in gently until it is fully seated.
5.
Remove the rubber safety cap when you are ready to connect the cable to the
6.
transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
Figure 62: Installing a Transceiver in an EX Series Switch
Removing a Transceiver from an EX Series Switch on page 220
Connecting a Fiber-Optic Cable to an EX Series Switch on page 159
Optical Interface Support in EX2200 Switches
Optical Interface Support in EX3200 Switches
Optical Interface Support in EX4200 Switches
Optical Interface Support in EX4500 Switches
Optical Interface Support in EX8200 Switches on page 60
EX Series switches have field-replaceable unit (FRU) optical transceivers to which you
can connect fiber-optic cables.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in an
EX Series switch, ensure that you have taken the necessary precautions for safe handling
of lasers (see "Laser and LED Safety Guidelines and Warnings for EX Series Switches"
on page 275).
Chapter 9: Installing Switch Components
159