Installing A Dc Power Supply In An Ex8200 Switch; Figure 52: Installing An Ac Power Supply In An Ex8200 Switch - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
Related
Documentation

Installing a DC Power Supply in an EX8200 Switch

146
Push the captive screw into the power supply faceplate. Ensure that the screw is
10.
seated inside the corresponding hole on the faceplate.
Tighten the captive screw by turning it clockwise using the Phillips (+) screwdriver,
11.
number 1. When the screw is completely tight, the latch locks into the switch chassis.

Figure 52: Installing an AC Power Supply in an EX8200 Switch

Removing an AC Power Supply from an EX8200 Switch on page 205
Calculating Power Requirements for an EX8208 Switch on page 108
Calculating Power Requirements for an EX8216 Switch
Field-Replaceable Units in an EX8208 Switch on page 25
Field-Replaceable Units in an EX8216 Switch
AC Power Supply in an EX8200 Switch on page 41
The DC power supply in an EX8200 switch is a hot-removable and hot-insertable
field-replaceable unit (FRU). Up to six DC power supplies can be installed in an EX8200
switch. All DC power supplies install in the front of the chassis in the slots provided at
the bottom. See "Slot Numbering for an EX8208 Switch" on page 13 and Slot Numbering
for an EX8216 Switch.
NOTE: EX8208 switches support 2000 W DC power supplies.
EX8216 switches support 3000 W DC power supplies.
Before you install a DC power supply in the switch:
Copyright © 2010, Juniper Networks, Inc.