Routine Maintenance; Chapter 14 Routine Maintenance; Handling And Storing Line Cards In Ex8200 Switches; Figure 92: Edges Of The Line Cards In An Ex8200 Switch - Juniper EX8208 Complete Hardware Manual

CHAPTER 14

Routine Maintenance

Handling and Storing Line Cards in EX8200 Switches

Copyright © 2010, Juniper Networks, Inc.
Handling and Storing Line Cards in EX8200 Switches on page 227
Maintaining Line Card Cables in EX8200 Switches on page 230
Maintaining Fiber-Optic Cables in EX Series Switches on page 231
Removing a Battery from an EX8208 Switch for Recycling on page 232
Components in the line cards are fragile. To avoid damaging the line cards, follow the
procedures in this topic. The procedures use the following terms to describe the four
edges of the line cards (see Figure 92 on page 227):

Figure 92: Edges of the Line Cards in an EX8200 Switch

Faceplate—Edge of the line card that has connectors into which you insert the
transceivers or RJ-45 cables.
Connector edge—Edge opposite the faceplate.
Top edge—Edge at the top of the line card when the line card is vertical.
Bottom edge—Edge at the bottom of the line card when the line card is vertical.
CAUTION: Failure to handle line cards as specified in these procedures can
cause irreparable damage to them.
227