Complete Hardware Guide for EX8208 Ethernet Switches
SF Module LEDs in an EX8208 Switch
Table 14: SF Module LEDs of an EX8208 Switch
LED (Description)
ST (Status)
SF (Switch Fabric)
Related
Documentation
8-port SFP+ Line Card in an EX8200 Switch
32
Taking the SF Module Offline in an EX8208 Switch on page 214
The Switch Fabric (SF) module has two LEDs on the left side of the module's front panel.
See Figure 11 on page 32.Table 14 on page 32 describes these LEDs, their colors and states,
and the status they indicate.
Figure 11: SF Module LEDs in an EX8208 Switch
Color
Green
Yellow
Unlit
Green
Yellow
Unlit
Installing an SF Module in an EX8208 Switch on page 151
Removing an SF Module from an EX8208 Switch on page 215
Taking the SF Module Offline in an EX8208 Switch on page 214
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
State and Description
On steadily—SF module is operating normally.
Blinking—Waiting to be configured by the master Switch Fabric
and Routing Engine (SRE) module.
SF module has failed.
SF module is offline.
On steadily—Switch fabric in SF module is operating normally.
Blinking—Switch fabric in SF module is offline.
On steadily—Switch fabric in SF module has failed.
SF module is powered off.
Copyright © 2010, Juniper Networks, Inc.