Removing An Ex8208 Switch From A Rack Or Cabinet Without Using A Mechanical Lift; Figure 79: Removing An Ex8208 Switch Chassis Using A Mechanical Lift - Juniper EX8208 Complete Hardware Manual

Related
Documentation

Removing an EX8208 Switch from a Rack or Cabinet Without Using a Mechanical Lift

Copyright © 2010, Juniper Networks, Inc.
To remove the switch using a lift (see Figure 79 on page 201):
Use the appropriate Phillips (+) screwdriver to remove the 24 mounting screws that
1.
attach the chassis front-mounting brackets to the rack or cabinet.
Move the lift to the rack and position it so that its platform is centered about 0.5 in.
2.
(1.27 cm) below the bottom of the switch chassis and as close to it as possible.
Carefully slide the switch from the adjustable mounting brackets attached to the rack
3.
onto the lift.
Use the lift to transport the switch to its new location.
4.

Figure 79: Removing an EX8208 Switch Chassis Using a Mechanical Lift

Removing an EX8208 Switch from a Rack or Cabinet Without Using a Mechanical Lift
on page 201
If you cannot use a mechanical lift to remove the switch (the preferred method), you can
remove it manually.
Chapter 12: Removing the Switch
201