Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
Related
Documentation

Connecting and Configuring an EX Series Switch (CLI Procedure)

188
}
protocols {
igmp-snooping {
vlan all;
}
lldp {
interface all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Configuration Files Terms
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 188
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 190
Understanding Configuration Files for EX Series Switches
EX8208 Switch Hardware Overview on page 3
EX8216 Switch Hardware Overview
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the EX Series Switch.
Before you begin connecting and configuring an EX Series switch through the console
using the CLI:
Set the following parameter values in the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
script, the switch must have the factory default
ezsetup
, revert to the factory default configuration.
ezsetup
Copyright © 2010, Juniper Networks, Inc.