Figure 76: Ethernet Cable Connector; Figure 77: Connecting An Ex Series Switch To A Network For Out-Of-Band; Management - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
To Management port
Related
Documentation
184

Figure 76: Ethernet Cable Connector

To connect a device to a network for out-of-band management (see Figure 77 on page 184):
Connect one end of the Ethernet cable to the management port (labeled
1.
the device.
For the location of the
See Rear Panel of an EX2200 Switch.
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX4200 Switch.
See Front Panel of an EX4500 Switch.
See "Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch" on
page 26.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
Connect the other end of the Ethernet cable to the management device.
2.

Figure 77: Connecting an EX Series Switch to a Network for Out-of-Band

Management

(on the switch)
Management
network
Connecting an EX Series Switch to a Management Console on page 178
Management Port Connector Pinout Information for an EX2200 Switch
Management Port Connector Pinout Information for an EX3200 Switch
Management Port Connector Pinout Information for an EX4200 Switch
port on different devices:
MGMT
Management PC
Management PC
Management PC
MGMT
Copyright © 2010, Juniper Networks, Inc.
) on