Complete Hardware Guide for EX8208 Ethernet Switches
Related
Documentation
Console Port Connector Pinout Information for an EX Series Switch
Table 30: EX Series Switches Console Port Connector Pinout Information
Pin
1
2
3
4
5
6
7
8
58
See Rear Panel of an EX2200 Switch for port location.
See Rear Panel of an EX3200 Switch for port location.
See Rear Panel of an EX4200 Switch for port location.
See Front Panel of an EX4500 Switch for port location.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 26
for port location.
See Routing Engine (RE) Module in an EX8216 Switch for port location.
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 30 on page 58 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Signal
RTS Output
DTR Output
TxD Output
Signal Ground
Signal Ground
RxD Input
CD Input
CTS Input
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
Copyright © 2010, Juniper Networks, Inc.