Copyright © 2010, Juniper Networks, Inc.
b. Secure each negative (–) DC source power cable lug to the
input terminal.
Each power supply has two independent sets of DC power input terminals (A: –48V
A: RTN and B: – 48V B: RTN ). For feed redundancy, each power supply should be
powered by dedicated power feeds derived from feed
provides the commonly deployed
NOTE: If the power cord tray is installed, you can thread the DC power
cables through the power cord tray.
Figure 69: Connecting the Power Supply Cables to an EX8200 Switch
Install the plastic cable cover over each set of power cables, using the number 2
8.
Phillips (+) screwdriver to tighten the screw (see Figure 70 on page 176).
Chapter 10: Connecting the Switch
A
and feed
feed redundancy for the switch.
A/B
(input) DC power
–48V
B
. This configuration
175