Figure 80: Removing An Ex8208 Switch Chassis Without Using A Mechanical - Juniper EX8208 Complete Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
Ensure that you have the following parts and tools available to remove the switch:
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack
mounting screws
To remove the switch from the rack (see Figure 80 on page 203):
Use the appropriate Phillips (+) screwdriver to remove the 24 mounting screws that
1.
attach the chassis front-mounting brackets to the rack or cabinet.
WARNING: To prevent injury, keep your back straight and lift with your
legs, not your back. Do not twist your body as you lift. Balance the load
evenly and be sure that your footing is firm.
With one person on each side and one person in the back, hold onto the bottom of
2.
the chassis and carefully lift it out of the adjustable mounting brackets attached to
the rack. If you have a pallet jack, move the switch onto the pallet jack.
Figure 80: Removing an EX8208 Switch Chassis Without Using a
Mechanical Lift
Carefully move the chassis to its new location.
3.
After you move the switch to its new location, reinstall the components in the chassis or
store the components in antistatic bags. See:
Chapter 12: Removing the Switch
203