Management Port Connector Pinout Information For An Ex8200 Switch; Front; Table 31: Management Port Connector Pinout Information For Ex8200 - Juniper EX8208 Complete Hardware Manual

Related
Documentation

Management Port Connector Pinout Information for an EX8200 Switch

Table 31: Management Port Connector Pinout Information for EX8200 Switches
Pin
1
2
3
4
5
6
7
8
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
See Rear Panel of an EX2200 Switch for port location.
See Rear Panel of an EX3200 Switch for port location.
See Rear Panel of an EX4200 Switch for port location.
See Front Panel of an EX4500 Switch for port location.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 26
for port location.
See Routing Engine (RE) Module in an EX8216 Switch for port location.
Connecting an EX Series Switch to a Management Console on page 178
The management port on an EX8200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the administrative
status of the port. See "Management Port LEDs in EX8200 Switches" on page 29.
Table 31 on page 59 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Signal
TRP1+
TRP1-
TRP2+
TRP3+
TRP3-
TRP2-
TRP4+
TRP4-
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 26
for port location.
See Routing Engine (RE) Module in an EX8216 Switch for port location.
Connecting an EX Series Switch to a Network for Out-of-Band Management on page 183
Chapter 3: Component Specifications
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
59