Lcd Panel Menus; Component Descriptions; Table 8: Lcd Panel Menu Options For The Ex8200 Switch - Juniper EX8208 Complete Hardware Manual

LCD Panel Menus

Table 8: LCD Panel Menu Options for the EX8200 Switch

Menu Description
Idle In the Idle menu:
Press
Enter
ADM (enabled/disabled)
SPD (speed)
DPX (duplex)
See "Network Port LEDs in an EX8200 Switch" on page 38 for information on the Status LED.
Press
Menu
Copyright © 2010, Juniper Networks, Inc.
The maintenance mode allows you to cycle through options for configuring and
troubleshooting the switch:
System halt
Reboot system
Load rescue configuration
Revert to factory configuration
EZSetup
The LCD has three menus: Idle, Status, and Maintenance. In each of these menus, line
one of the LCD panel displays the hostname of the switch. Toggle between the LCD
menus by pressing the Menu
button.
Enter
Table 8 on page 21 describes the LCD menu options.
to cycle through the Status LED modes, which are port status indicators:
to exit the Idle menu and go to the Status menu.
button. Navigate through the menu options by pressing the
Chapter 2: Component Descriptions
21