48-Port Rj-45 Line Card In An Ex8200 Switch; Figure 16: 48-Port Rj-45 Line Card - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
Related
Documentation

48-port RJ-45 Line Card in an EX8200 Switch

Related
Documentation
36
8-port SFP+ Line Card in an EX8200 Switch on page 32
40-port SFP+ Line Card in an EX8200 Switch on page 33
48-port RJ-45 Line Card in an EX8200 Switch on page 36
Optical Interface Support in EX8200 Switches on page 60
Installing a Line Card in an EX8200 Switch on page 154
Handling and Storing Line Cards in EX8200 Switches on page 227
The line cards in EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
The 48-port RJ-45 line card requires Junos OS for EX Series switches, Release 9.4 or
later.
EX8200 switches use four types of line cards. You can use any combination of line cards
in an EX8200 switch.
The 48-port RJ-45 line card for EX8200 switches (see Figure 16 on page 36) has 48
10/100/1000 Gigabit Ethernet ports with RJ-45 connectors on the faceplate. Each port
has two LEDs. See "Network Port LEDs in an EX8200 Switch" on page 38.

Figure 16: 48-port RJ-45 Line Card

The line card has two status LEDs labeled ON and ST on the faceplate that indicate the
online and status information for the line card. See "Line Card LEDs in an EX8200 Switch"
on page 37.
8-port SFP+ Line Card in an EX8200 Switch on page 32
40-port SFP+ Line Card in an EX8200 Switch on page 33
48-port SFP Line Card in an EX8200 Switch on page 35
Copyright © 2010, Juniper Networks, Inc.