Mazda RX-8 Workshop Manual page 1407

Front Upper Arm Removal Note
1. Remove the front upper arm bolts.
2. Push down the front lower arm, and then remove the front upper arm from the gap between the shock
absorber lower end and the front lower arm.
Clip Installation Note
1. Wipe the grease off the ball joint stud.
2. Fill the inside of the new dust boot with grease.
3. Install the dust boot on the ball joint.
4. Install the clip using the SST.
5. Verify that the clip is installed securely to the groove.
6. Wipe off any excess grease.
< Previous Next >
© 2010 Mazda North American Operations, U.S.A.
Back to Top