Front Panel Setup - Cisco D9040 User And Service Manual

Front Panel Setup

Setting Up the IP Parameters of the D9040 Encoder
Always verify that the IP parameters of the D9040 Encoder are correct before you
try to control the unit for the first time from the PNC control system. Also do as
follows when a D9040 Encoder is added to or reinserted in the installation.
Proceed as follows to set the IP settings of the D9040 Encoder, and if necessary
change them:
1. Press the MENU key on the front panel of the D9040 Encoder.
The MENU key toggles between the start up display and the main menu.
2. From the main menu press the SELECT key. You have now entered the System
menu.
3. From the System menu, press the RIGHT arrow once and the SELECT. You have
now entered the IP menu.
4. Go to the desired menu item and press the SELECT.
You use the right and left arrow keys to navigate to the desired menu item.
5. If necessary change the value.
Use the right arrow key to navigate to the digit to change and press one of the
numeric keys to enter a value. Press the SELECT key to store the entered
value(s).
6. If necessary, change the other IP parameters as described in steps 3 and 4 above.
7. Press the UP arrow to leave the IP menu.
Note: When you leave the IP menu by pressing the UP Arrow key the IP, Mask
and Gateway parameters are validated against each other and stored. Any
inconsistencies will be shown in the display.
Important: For the changes to take effect you must reset the D9040 Encoder
after you have finished setting or changing the IP address, subnet mask and
default gateway. Proceed as follows to reset the D9040 Encoder.
8. From the main menu, press the SELECT key to naviage to the System menu. You
have now entered the System menu.
9. Press the RIGHT arrow key eight times to reach the Reset menu. Press SELECT
and SELECT once more to confirm the reset.
Note: The reset make take up to 120 seconds.
4020024 Rev C
Quick Setup - Read Me First! 1-3