Table 20: Time Auto Updating - Grandstream Networks UCM6102 User Manual

The current system time on the UCM6100 is displayed on the upper right of the web page. It can also be
found under Web GUI->Status->System Status->General.
To configure the UCM6100 to update time automatically, go to Web GUI->Settings->Time Settings-
>Time Auto Updating.
Note:
The configurations under Web GUI->Settings->Time Settings->Time Auto Updating page require
reboot to take effect. Please consider configuring auto time updating related changes when setting up the
UCM6100 for the first time to avoid service interrupt after installation and deployment in production.
Remote NTP Server
Enable DHCP Option 2
Enable DHCP Option 42
Time Zone
Self-Defined Time Zone
Firmware Version 1.0.7.11

Table 20: Time Auto Updating

Specify the URL or IP address of the NTP server for the UCM6100 to
synchronize the date
ntp.ipvideotalk.com.
If set to "Yes", the UCM6100 is allowed to get provisioned for Time Zone
from DHCP Option 2 in the local server automatically. The default setting
is "Yes".
If set to "Yes", the UCM6100 is allowed to get provisioned for NTP Server
from DHCP Option 42 in the local server automatically. This will override
the manually configured NTP Server. The default setting is "Yes".
Select the proper time zone option so the UCM6100 can display correct
time accordingly.
If "Self-Defined Tome Zone" is selected, please specify the time zone
parameters in "Self-Defined Time Zone" field as described in below
option.
If "Self-Defined Time Zone" is selected in "Time Zone" option, users will
need define their own time zone following the format below.
The syntax is: std offset dst [offset], start [/time], end [/time]
Default is set to: MTZ+6MDT+5,M4.1.0,M11.1.0
MTZ+6MDT+5
UCM6100 Series IP PBX User Manual
and time. The default NTP server is
Page 55 of 233