Display Name
Sender
The following figure shows a sample Email settings on the UCM6100, assuming the Email is using
smtp.gmail.com as the SMTP server.
Once the configuration is finished, click on "Test". In the prompt, fill in a valid Email address to send a test
Email to verify the Email settings on the UCM6100.
TIME SETTINGS
The current system time on the UCM6100 is displayed on the upper right of the web page. It can also be
found under Web GUI->Status->System Status->General.
To configure the UCM6100 to update time automatically, go to Web GUI->Settings->Time
Settings->Time Auto Updating.
Firmware Version 1.0.5.19
Specify the display name in the FROM header in the Email.
Specify the sender's Email address.
For example, pbx@example.mycompany.com.
Figure 18: UCM6100 Email Settings
Table 19: Time Auto Updating
UCM6100 Series IP PBX User Manual
Page 48 of 183