Call Features; Feature Codes; Table 57: Ucm6100 Feature Codes - Grandstream Networks UCM6102 User Manual

The UCM6100 supports call recording, transfer, call forward, call park and other call features via feature
code. This section lists all the feature codes in the UCM6100 and describes how to use the call features.

FEATURE CODES

Feature Maps
Blind Transfer
Attended Transfer
Disconnect
Firmware Version 1.0.7.11

CALL FEATURES

Table 57: UCM6100 Feature Codes


Default code: #1.

Enter the code during active call. After hearing "Transfer", you
will hear dial tone. Enter the number to transfer to. Then the
user will be disconnected and transfer is completed.

Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.

Default code: *2.

Enter the code during active call. After hearing "Transfer", you
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer.

Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.

Default code: *0.

Enter the code during active call. It will disconnect the call.

Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
UCM6100 Series IP PBX User Manual Page 177 of 233