Grandstream Networks UCM6102 User Manual page 128

Maximum Call Duration
Warning Time
Warning Repeat Interval
Privilege Level
Enable Filter on Source Caller
ID
Firmware Version 1.0.7.11
outbound route.
Configure the maximum duration of the call (in seconds). The default
setting is 0, which means no limite.
Configure the warning time for the call using this outbound route. If set to
x seconds, the warning tone will be played to the caller when x seconds
are left to end the call.
Configure the warning repeat interval for the call using this outbound
route. If set to x seconds, the warning tone will be played every x
seconds after the first warning.
Select privilege level for the outbound rule.

Internal: The lowest level required. All users can use this rule.

Local: Users with Local, National, or International level are allowed to
use this rule.

National: Users with National or International level are allowed to use
this rule.

International: The
international level can use this rule.
The default setting is "Disable". Please be aware of the potential security
risks when using "Internal" level, which means all users can use this
outbound rule to dial out from the trunk.
When enabled, users could specify extensions allowed to use this
outbound route. "Privilege Level" is automatically disabled if using
"Enable Filter on Source Caller ID".
The following two methods can be used at the same time to define the
extensions as the source caller ID.
1. Select available extensions/extension groups from the left to the
right. This allows users to specify arbitrary single extensions
available in the PBX.
2. Custom Dynamic Route: define the pattern for the source caller ID.
This allows users to define extension range instead of selecting them
one by one.

All patterns are prefixed with the "_".

Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
UCM6100 Series IP PBX User Manual
highest level required. Only users with
Page 126 of 233