Time Settings; Auto Time Updating; Table 21: Time Auto Updating; Figure 49: Email Logs - Grandstream Networks UCM6100 Series User Manual

Email logs will be shown on bottom of the "Email Send Log" page, as shown on the following figure.

Time Settings

Auto Time Updating

The current system
StatusDashboardPBX Status.
To configure the UCM6100 to update time automatically, go to Web GUISystem SettingsTime
SettingsAuto Time Updating.
-------------------------------------------------------------------------------------------------- ------------------------------------------
Note:
The configurations under Web GUISystem SettingsTime SettingsAuto Time Updating page
require reboot to take effect. Please consider configuring auto time updating related changes when setting
up the UCM6100 for the first time to avoid service interrupt after installation and deployment in production.
--------------------------------------------------------------------------------------------------------------------------------------------
Remote NTP Server
Enable DHCP Option 2
Enable DHCP Option 42

Figure 49: Email Logs

time on the UCM6100

Table 21: Time Auto Updating

Specify the URL or IP address of the NTP server for the UCM6100 to
synchronize the
ntp.ipvideotalk.com.
If set to "Yes", the UCM6100 is allowed to get provisioned for Time Zone
from DHCP Option 2 in the local server automatically. The default is "Yes".
If set to "Yes", the UCM6100 is allowed to get provisioned for NTP Server
from DHCP Option 42 in the local server automatically. This will override
the manually configured NTP Server. The default setting is "Yes".
UCM6100 Series User Manual
can be found under
date and time. The
Web GUISystem
default NTP server is
P a g e 87
|