Email logs will be shown on bottom of "Email Send Log" page, as shown on the following figure.
Time Settings
Auto Time Updating
The current system time on the UCM6510 is displayed on status web page. It can be found under Web
GUISystem StatusDashboard.
To configure the UCM6510 to update time automatically, go to Web GUISystem SettingsTime
SettingsAuto Time Updating.
Note:
The configurations under Web GUISystem SettingsTime SettingsTime Auto Updating page
require reboot to take effect. Please consider configuring auto time updating related changes when setting
up the UCM6510 for the first time to avoid service interrupt after installation and deployment in production.
Remote NTP Server
Enable DHCP Option 2
Enable DHCP Option 42
Time Zone
Figure 56: Email Logs
Table 21: Auto Time Updating
Specify the URL or IP address of the NTP server for the UCM6510 to
synchronize
the
date
ntp.ipvideotalk.com.
If set to "Yes", the UCM6510 can get provisioned for Time Zone from DHCP
Option 2 in the local server automatically. The default setting is "Yes".
If set to "Yes", the UCM6510 is allowed to get provisioned for NTP Server
from DHCP Option 42 in the local server automatically. This will override
the manually configured NTP Server. The default setting is "Yes".
Select the proper time zone option so the UCM6510 can display correct
time accordingly.
If "Self-Defined Tome Zone" is selected, please specify the time zone
parameters in "Self-Defined Time Zone" field as described in below option.
UCM6510 IP PBX User Manual
and
time.
The
default
NTP
server
is
P a g e
|
89