Connect The Ucm6108; Figure 6: Ucm6108 Front View; Figure 7: Ucm6108 Back View - Grandstream Networks UCM6102 User Manual

CONNECT THE UCM6108

To set up the UCM6108, follow the steps below:
 Connect one end of an RJ-45 Ethernet cable into the LAN port of the UCM6108.
 Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub.
 Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6108. Insert
the main plug of the power adapter into a surge-protected power outlet.
 Wait for the UCM6108 to boot up. The LCD in the front will show the device hardware information
when the boot process is done.
 Once the UCM6108 is successfully connected to network, the LED indicator for NETWORK in the
front will be in solid green and the LCD shows up the IP address.
 (Optional) Connect PSTN lines from the wall jack to the FXO ports; connect analog lines (phone and
Fax) to the FXS ports.
Firmware Version 1.0.7.11

Figure 6: UCM6108 Front View

Figure 7: UCM6108 Back View

UCM6100 Series IP PBX User Manual Page 28 of 233