Connect The Ucm6104; Figure 4: Ucm6104 Front View; Figure 5: Ucm6104 Back View - Grandstream Networks UCM6102 User Manual

CONNECT THE UCM6104

To set up the UCM6104, follow the steps below:
 Connect one end of an RJ-45 Ethernet cable into the LAN 1 port of the UCM6104.
 Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub.
 Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6104. Insert
the main plug of the power adapter into a surge-protected power outlet.
 Wait for the UCM6104 to boot up. The LCD in the front will show the device hardware information
when the boot process is done.
 Once the UCM6104 is successfully connected to network, the LED indicator for LAN 1 in the front will
be in solid green and the LCD shows up the IP address.
 (Optional) Connect PSTN lines from the wall jack to the FXO ports; connect analog lines (phone and
Fax) to the FXS ports.
Firmware Version 1.0.7.11

Figure 4: UCM6104 Front View

Figure 5: UCM6104 Back View

UCM6100 Series IP PBX User Manual Page 27 of 233