Iax Settings/Static Defense; Table 66: Iax Settings/Static Defense - Grandstream Networks UCM6102 User Manual

Auto Kill
Authentication Debugging
Codec Priority
Type of Service
IAX Trunk Options
Trunk Frequency
Trunk Time Stamps

IAX SETTINGS/STATIC DEFENSE

Call Token Optional
Max Call Numbers
Max Unvalidated Call Numbers
Call Number Limits
IP or IP Range
Firmware Version 1.0.7.11
setting is 100.
If set to "yes", the connection will be terminated if ACK for the NEW
message is not received within 2000ms. Users could also specify
number (in milliseconds) in addition to "yes" and "no". The default setting
is "yes".
If enabled, authentication traffic in debugging will not show. The default
setting is "No".
Configure codec negotiation priority. The default setting is "Reqonly".

Caller
Consider the callers preferred order ahead of the host's.

Host
Consider the host's preferred order ahead of the caller's.

Disabled
Disable the consideration of codec preference all together.

Reqonly
This is almost the same as "Disabled", except when the requested
format is not available. The call will only be accepted if the requested
format is available.
Configure ToS bit for preferred IP routing.
Configure the frequency of trunk frames (in milliseconds). The default
setting is 20.
If enabled, time stamps will be attached to trunk frames. The default
setting is "No".

Table 66: IAX Settings/Static Defense

Enter a single IP address (e.g., 11.11.11.11) or a range of IP addresses
(11.11.11.11/22.22.22.22) for which call token validation is not required.
Configure the maximum number of calls allowed for a single IP address.
Configure the maximum number of unvalidated calls for all IP addresses.
Configure to limit the number of calls for a give IP address of IP range.
Enter the IP address (11.11.11.11) or a range of IP addresses
(11.11.11.11/22.22.22.22) to be considered for call number limits.
UCM6100 Series IP PBX User Manual Page 190 of 233