Inbound Rule Configurations; Table 42: Inbound Rule Configuration Parameters - Grandstream Networks UCM6102 User Manual


Click on to delete the inbound route.

INBOUND RULE CONFIGURATIONS

Trunks
DID Pattern
Privilege Level
Default Destination
Firmware Version 1.0.7.11

Table 42: Inbound Rule Configuration Parameters

Select the trunk to configure the inbound rule.

All patterns are prefixed with the "_".

Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.

The pattern can be composed of two parts, divided by a '/' character.
The first part is used to specify the dialed number the second part is
used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID is allowed to call in or call out.
For example, patter '_2XXX/1234' means the only extension with the
caller ID '1234' is allowed to use this rule.
Configure the privilege level for this inbound route.
Select the default destination for the inbound call.

Extension

Voicemail

Conference Room

Queue

Ring Group

Paging/Intercom

Voicemail Group

Fax

DISA

IVR

Dial By Name

External Number

By DID
When "By DID" is used, the UCM6100 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
UCM6100 Series IP PBX User Manual Page 128 of 233