Web Info
USE THE LED INDICATORS
The UCM6100 has LED indicators in the front to display connection status. The following table shows the
status definitions.
LED Indicator
LAN
WAN
USB
SD
FXS (Phone/Fax)
FXO (Telco Line)
LED
NETWORK
ACT
USB
SD
Phone (FXS)
Line (FXO)
Firmware Version 1.0.7.11
Select "All On" "All Off" or "Blinking" and check LED status.
RTC Test Patterns
Select "2022-02-22 22:22" or "2011-01-11 11:11" to start the RTC (Real-
Time Clock) test pattern. Then check the system time from LCD idle
screen by pressing "DOWN" button, or from web GUI->System Status-
>General page. Reboot the device manually after the RTC test is done.
Hardware Testing
Select "Test SVIP" to perform SVIP test on the device. This is mainly for
factory testing purpose which verifies the hardware connection inside the
device. The diagnostic result will display in the LCD after the test is done.
Protocol: Web access protocol. HTTP or HTTPS. By default it's HTTPS
Port: Web access port number. By default it's 8089
Table 5: UCM6102/UCM6104 LED INDICATORS
LED Status
Table 6: UCM6108/UCM6116 LED INDICATORS
LED Status
UCM6100 Series IP PBX User Manual
Solid: Connected
Flashing: Data Transferring
OFF: Not Connected
Solid: Connected
OFF: Not Connected
Solid: Connected
Flashing: Data Transferring
OFF: Not Connected
Page 33 of 233